Roof windows on Redcliffe buildings
On older terraces, fitting a roof window usually means cutting into an existing slope. Rafters may need trimming and doubling up around the opening, and we check the structure on site before saying what is possible, instead of promising it from a photograph. That honest check up front saves wasted effort and keeps the plan realistic for the building.
Converted buildings and flats vary a great deal. Some have roofs that suit a standard window, others have shallow slopes, parapets or limited reach, and the right flashing kit depends on the roof covering. We match the kit to your roof rather than forcing a generic fit. It is a better start than a generic kit that nearly fits.
Tight sites matter here too. Lifting a window into place, protecting the room below and keeping the roof closed up each day all take planning, and we agree access, working hours and any scaffold with you ahead of time. A clear plan keeps disruption low. That check keeps the plan realistic for the building in front of us.
Roof window jobs in Redcliffe
- New roof window in an existing slope. We open the roof, frame the opening, fit the window with the correct flashing kit and reinstate the covering around it.
- Replacing old or leaking windows. Worn windows are removed and a new unit fitted, with fresh flashings so the opening is sealed properly into the covering.
- Misted or failed sealed units. If a window has misted between the panes, the sealed unit has usually failed, and we can advise on replacing the unit or the whole window.
- Loft conversion roof windows. For loft conversions, we fit windows to suit the room layout and the roof, working with other trades on lining and insulation.
- Lining, insulation and vapour control. The opening is lined and insulated, with vapour control, so the window finishes cleanly inside and condensation is less likely.
- Flashing and sealing repairs. Leaks around a roof window are usually down to flashing or sealing rather than the glass, and we repair or renew them.
How we install roof windows here
We start by looking at the roof covering, the rafters and the room below. This tells us which flashing kit is needed and whether the framing around the opening needs strengthening. Then we explain the plan, including what is done from outside and what from inside. We explain each stage as we go, so there are no surprises about what happens next.
On the day, the room below is protected and the roof is opened only as far as needed, then closed up before we leave. After the window is in, the lining, insulation and vapour control are finished, and we show you how it opens and how to keep it clean.