Roof windows in Sneyd Park's tall villa roofs
Villa roofs here are steep and covered in slate or tile, and the flashing kit has to match the covering exactly. A kit for the wrong material can leak. We identify your roof covering first, then select the right kit and fit it with care at the exposed height these houses stand.
Long slopes give plenty of choice for position, but the rafters and existing timbers decide what is practical. Older roofs can have large, widely spaced rafters, and these may need trimming and doubling up around the opening. We check that from the roof space before agreeing anything. Where the weather is against us, we wait for a safe window to carry on.
Windows put in on older villa roofs often leak at the flashing, the sealing or the covering around the frame, not through the glass. Misting between panes means the sealed unit has failed. Trees nearby add leaf debris and shade, which can aggravate faults, so we look at the whole surround. Our advice is the same whether the job is small or large.
Roof window work in Sneyd Park
- New roof window installation. Forming the opening, trimming and doubling up rafters where needed, and fitting the window with a matched flashing kit.
- Replacing old roof windows. Removing worn or leaking windows from villa roofs and fitting new ones, with fresh flashings and a sealed, insulated surround.
- Attic and loft conversion windows. Fitting roof windows as part of an attic room, with lining, insulation and vapour control formed around each opening.
- Flashing and seal repairs. Dealing with leaks that start at the flashing, sealing or surrounding covering, where the window itself is still in good order.
- Misted unit replacement. Replacing sealed glazing units that have failed and misted, which cannot be cleared by cleaning.
- Window groups and stair lighting. Positioning windows over landings and stairs, or in pairs on a long slope, to bring light into the middle of a large house.
How we fit a roof window on a villa
We start in the loft, studying the rafters, the existing insulation and the layout of the room. Then we check the slate or tile outside to choose the right flashing kit. We tell you plainly if the rafters need work, and why, before anything is cut. We leave you with a clear account of what was found and what was done.
Roofs at this height need proper access, so scaffold or a tower is set up where required, and the room below is protected while the roof is open. After fitting, we line and insulate the opening and fit vapour control. Some fittings may need planning or Building Regulations checks, and we advise before work starts.