Why Redland gables suit a dry verge
Large houses here tend to have gables on more than one elevation, so the length of verge is considerable and every metre of it sits high and exposed. Wind pulls at those edges first. On older houses the original mortar has often been patched already, and each patch is weaker than the last. Putting it right while the damage is small keeps the job simple.
Mortar that falls onto a long path or drive is a nuisance, and loose pieces overhead are a risk before the next gust arrives. Open cracks along a verge also let weather, birds and insects into the roof edge. With several gables, it makes sense to look at all of them in one visit, not only the one shedding debris.
A dry verge is not a cure for a roof that is failing elsewhere, so we check the wider covering as well. Whether the units suit depends on the tile profile, which we confirm on site, and they are fixed following the tile maker's guidance. If your tiles will not take them, we say so and suggest another way of finishing the edge.
Dry verge jobs on Redland gables
- Dry verge during a re-roof. When the whole roof is being recovered, dry verge goes in from the outset so every gable edge is finished without wet mortar.
- Replacing crumbling bedding. Loose, cracked or missing mortar is cleared away and mechanically fixed verge units take its place along the gable.
- Tile-end and cap pieces. Pieces made for your tile are fixed along the edge to close it off neatly and keep weather, birds and insects out.
- Fixing to the maker's guidance. Units are secured with the fixings and spacing the tile maker recommends for the particular tile on your roof.
- Multi-gable houses. Where there are several gables we repair the verges that have failed and tell you which of the others look likely to follow.
- Profile checks on site. Before work is agreed, we confirm at the roof that your tile profile will accept dry verge units properly.
Our dry verge method on Redland houses
We start with the edge and the tiles beside it, judging how far the mortar has failed and whether any tiles have shifted. Then we confirm the profile suits dry verge and explain the findings, including any case where it would not. Photographs are shared where they make things clearer. You see the same picture we do.
Work follows the tile maker's fixing guidance. Old bedding comes off, tiles are checked, and the units and end pieces are fixed mechanically. Gables on tall houses usually need scaffold, arranged ahead of time, and we keep paths, drives and borders clear of debris and sweep up before leaving, so the edge is neat from the street.