Fascia and soffit work in Chipping Sodbury
The exposed Cotswold-edge weather is hard on roof edges. Driving rain soaks fascias, wind works loose joints and boards that were once tight pull away at the corners. Boards on the windward side tend to deteriorate first, so one face of a house can look fine while another is failing. Spotting it early keeps replacement simple.
Along the main street the older stone and brick buildings often have eaves built differently from modern houses, with deeper overhangs or boxed details. We look at what exists and design the replacement around it. We also check what existing soffit boards are made of before disturbing them, as a calm routine step. That keeps the new boards sitting properly against the walls and rafters.
The newer estates are more straightforward. Standard eaves and uniform runs make the work quicker, and a full replacement often brings a visible lift to the house. Vented soffits go in as standard where the roof space needs air movement to stay dry. That also helps stop damp building up in the roof timbers over time, which is a common cause of trouble.
Fascia and soffit options in Chipping Sodbury
- Full fascia and soffit replacement. Old boards and gutters come off, the rafter ends and eaves are checked, and new UPVC is fitted along the whole roof edge.
- Bargeboard replacement. Boards along the gable edge replaced so the sides of the roof are neatly finished and match the eaves.
- Vented soffits. Vented boards or vent strips let the loft breathe, helping keep roof timbers and insulation dry.
- Gutters fitted alongside. New gutters and downpipes added while the scaffold is up, so the eaves line is finished in one visit.
- Capping or replacing. If the timber behind is sound, UPVC can be capped over it; if it is soft, it is taken off and replaced.
- Repairs and partial replacement. One rotten board or a single damaged corner dealt with without renewing every board on the house.
How we carry out the work in Chipping Sodbury
Scaffold or safe access goes up first, since the work sits at eaves height. We take down the gutters and old boards, then inspect the rafter ends and the eaves. Any damp or damaged timber is dealt with before new boards are fitted. Nothing is covered over that has not been looked at first.
New UPVC goes on in white, or in darker and wood-effect finishes if you prefer. We include vented soffits where needed, refit or replace the guttering, and check the water runs to the outlets as it should before the scaffold comes down. We clear the site tidily when finished. All waste goes with us.
