Fascia and Soffit Work on Filton's Older Estates
Hipped roofs mean eaves on all four sides, with corners where the boards turn at the hip. These corners are a weak point where old boards open up and water gets in, so we pay close attention when we remove and refit them. Open corners are the places we look at hardest before refitting.
Many inter-war houses were built with timber soffits, and some may be an older material that needs checking before it is disturbed. We look at what is there first and handle it calmly and correctly, rather than assume. We explain clearly what we find and what it means for the job, before any board is touched.
Post-war and modern homes in Filton often already have UPVC that is now tired or stained, and gutters that have sagged. In those cases we can replace boards and gutters together, or cap over sound boards, depending on their condition. Which route suits depends on the state of the boards, and we advise honestly.
Fascia and Soffit Services in Filton
- Full fascia and soffit replacement. Taking down old boards all round the eaves and fitting new UPVC fascias and soffits, including the corners at the hips.
- Bargeboards on gable ends. Replacing damaged or rotten bargeboards on gable ends, which take weather from the open aspect of Filton's wide streets.
- Vented soffits. Fitting vented soffit boards or strips so the roof space can breathe, protecting rafters and loft insulation from damp.
- Gutter and downpipe replacement. Fitting new guttering with the new boards, so water is carried away cleanly and no old drips damage the fresh fascias.
- Capping or replacing existing boards. Covering sound old boards where that suits, or taking them out completely when they are warped, cracked or rotting.
- Repairs and partial replacement. Renewing a section of damaged fascia, a cracked corner or part of a soffit without disturbing a sound run of boards.
How We Replace Boards on Filton Homes
The long eaves of a hipped roof need scaffold or a tower, and wide streets and driveways usually give room for it. We agree its position with you first. Before removing anything, we check what the existing soffit boards are made of and handle them accordingly. We also keep the work area tidy.
Old boards and gutters come off, then we look at the rafter ends and the eaves for rot or damp. New boards are fitted with vents where the roof space needs them, and gutters are refitted or replaced. White, darker and wood-effect finishes are all available. The fit is checked all round before we leave.