Fascias and Soffits on Kingsweston's Post-War Homes
Many houses on the Kingsweston Hill and Lawrence Weston side were built after the war with timber fascias and soffits that have been painted and repainted for decades. Where paint has failed, water gets into the board and rot follows. Because the houses were built in matching groups, boards on neighbouring homes often fail in the same places at about the same time.
Wind on this open higher ground plays its part. Gusts work at loose boards and sagging gutters, and rain driven up under the eaves finds every gap, so rot often starts at joints and the ends of boards. Long gutter runs on exposed elevations flex and pull their brackets out of softened timber.
Behind the boards are the rafter ends, and these are what we check as the old fascias come off. If they have stayed dry, new boards go straight on. If they have been wet for a long time, we deal with that before anything is fixed. On a house that has stood on high ground for decades, the gable end boards are commonly the worst.
Fascia and Soffit Work Available in Kingsweston
- Full fascia and soffit replacement. Removing all old boards and fitting new UPVC fascias and soffits around the whole roof, with the rafter ends checked as they are exposed.
- Bargeboard replacement. Renewing the boards along gable edges, where rain and wind combine to rot timber and pull fixings loose.
- Vented soffits. Fitting soffits with built-in ventilation or vent strips so the roof space can breathe and condensation does not build up in the loft.
- Gutter replacement alongside. Fitting new gutters while the boards are off, which is far easier than doing it separately and avoids new boards carrying old gutters.
- Capping over sound boards. Covering good timber with UPVC where the boards beneath are still solid, as a lower-disruption option than full removal.
- Repairs and partial replacement. Replacing a few damaged lengths, such as a rotten corner or an end board, where the rest of the run is still in good order.
How We Replace Fascias and Soffits in Kingsweston
The job needs scaffold or safe access, so we plan that first. Older properties may have soffit boards made of something other than timber, so we check what is there before disturbing it. Then the old boards and gutters come off and we look at the rafter ends and eaves. We also tell you whether any ventilation is missing from the eaves, as many older roofs have none.
New boards are fitted level and true, with vented soffits or vent strips where the roof space needs air, and gutters refitted or replaced. White is the usual choice, but darker and wood-effect finishes are available if you want something different. Everything is cleared away at the end, and you are shown the finished line of the eaves from the ground.