Roof windows in Hanham homes and lofts
Hanham's older terraces and village houses often have steep, deep roof slopes with lofts that could be put to better use. A roof window can turn a dim attic into a usable room, though it has to suit the roof structure and covering. On older terraces especially, the loft height and the condition of the rafters decide how far you can go.
The inter-war and post-war estates include many semis and bungalows with roomy lofts, and roof windows are a neat way to light them without a dormer. Sloping streets sometimes mean the best access is awkward, so we plan the lift and scaffold in advance. The same approach works for loft conversions where the windows need to line up with the new rooms below.
Open edges towards the river see more wind and driven rain, so the flashing and sealing at a roof window needs care. Rafters may need trimming and doubling up to take the opening, and we check that on site before any tile or slate is lifted. Getting this right keeps the new opening tight in rough weather.
Roof window work in Hanham
- New roof window in an existing loft. We cut the opening, frame it with doubled rafters where needed and fit the window with a flashing kit matched to your roof.
- Replacing old roof windows. Tired windows with failed seals or tired flashing are swapped for new units, with the surround checked and re-flashed as part of the job.
- Loft conversion roof windows. For loft rooms, windows are positioned to give light and ventilation, with linings and insulation completed around each opening.
- Bungalow and dormer lofts. Bungalow roofs and dormer cheeks can take roof windows too, and we check the structure and covering before agreeing a layout.
- Flashing and sealing repairs. Where a window leaks, we check the flashing, sealing and surrounding covering first and repair the real fault rather than guessing at the glass.
- Misting and failed sealed units. Condensation trapped between panes means the sealed unit has failed, and we advise on replacing the glass or the whole window.
How we install a roof window in Hanham
We start by looking at the roof covering and the loft from inside. The type of tile or slate decides the flashing kit, and the rafter layout decides whether any need trimming and doubling up. Those checks happen on site, not from a drawing. We then agree where each window sits and how it will look from outside.
Once the window is set, we complete the lining, insulation and vapour control around the opening so the new reveal is warm and sealed. Planning or Building Regulations checks may apply, and we advise before work starts. Where an existing window is being swapped, we check the old flashing and surrounding tiles before reusing anything, because a new window in a tired surround soon leaks. A tidy internal finish completes the job, with the lining boards decorated-ready.