Roof Windows on Kingswood's Hipped Roofs
The hipped tiled roofs on Kingswood's inter-war and post-war estates give a loft with sloping sides all round. That limits where a window can go, and the position of a hip, a chimney or a ridge decides what is possible. Inter-war loft space is often reached by a simple hatch with limited headroom, so the pitch and the ridge height matter before anything is agreed.
On a hipped roof the rafters at the corners run differently, so we check the framing carefully. A window sitting in the main slope usually has the most room, and rafters may need trimming and doubling up around the opening. Flat garage and extension roofs are not suited to this work, and we say so when the main slope is the only realistic option.
Houses with an existing window often report a drip or misting. These usually come from flashing, sealing or the tiles around the window rather than the glass, apart from a misted unit, where the sealed glass has failed and the window needs replacing. A new window lets in light, but also more heat loss and condensation if the surround is poorly insulated, so we finish the reveal carefully.
Roof Window Work in Kingswood
- New window in an unused loft. Opening up the roof and fitting a roof window with a flashing kit suited to your tiles, plus lining and insulation around the reveal.
- Replacing leaking windows. Taking out old windows and fitting new ones, checking the flashing and the tiles around the opening as part of the job.
- Windows for loft conversions. Fitting roof windows to suit a loft room, with sensible positioning for light, ventilation and reaching the glass from inside.
- Misted unit replacement. Replacing windows where moisture sits between the panes, which means the sealed glass has failed and cannot be repaired.
- Flashing and sealing repairs. Putting right leaks that come from the surround rather than the window, without replacing a unit that is otherwise fine.
- Rafter trimming and doubling. Framing the opening properly, trimming rafters and doubling them up where needed, checked on site before cutting.
How We Install Roof Windows in Kingswood
First we go into the loft. We look at the rafters, the pitch and the head height, and check where a window could sit. If rafters need trimming, we explain how the opening will be framed. Then we match the window to a flashing kit for your tiles. Windows come in a range of sizes, and we help you pick one that fits between the rafters without extra framing where possible.
Inside, the reveal is lined and insulated with a vapour control layer to limit condensation. A new opening may need planning or Building Regulations checks, and we advise before work starts. We go through size and position with you first, so there are no surprises. We also leave you with a clear idea of how to open, close and clean the window.