Roof windows on Patchway houses
Many Patchway semis from the inter-war and post-war estates have roof spaces that make good use of a roof window, whether for a loft conversion or simply to light a landing or storage room. The hipped roofs mean the rafter layout varies, so each opening is checked individually. That planning stage is where most of the care goes.
Bungalow lofts are another good fit. A roof window can bring daylight and ventilation into a space that was never designed as a room, and because the roof is lower, access to the roof and the way the flashing sits need careful planning. Getting that detail right keeps the new window from becoming a leak later.
Where an older window is leaking, the glass is rarely the culprit. Usually it is the flashing, the sealing, condensation or the tiles around it, though a misting pane does mean the sealed unit has failed. We look at the whole opening before deciding whether to replace. Only then do we recommend repair or replacement.
Roof window work in Patchway
- New roof window installation. A new opening is formed, the rafters are trimmed and doubled where needed, and the window is fitted with a flashing kit matched to the roof covering.
- Replacing old roof windows. Tired or leaking windows are removed and a new unit fitted with fresh flashing, so the opening is renewed rather than simply patched.
- Loft conversion windows. Where a loft is being turned into a room, we fit the windows to suit the layout, with proper lining and insulation around each opening.
- Bungalow and dormer lofts. Windows in bungalow roofs and dormer lofts are fitted with care over low eaves and tight spaces, keeping the covering around them watertight.
- Flashing and sealing repairs. Where a window leaks at its edges, we renew the flashing or sealing and check the covering around it before refitting.
- Misted units and glazing. A misted pane means the sealed unit has failed, and we advise whether the unit alone or the whole window should be replaced.
How we install roof windows in Patchway
We begin in the loft to see the rafters, the insulation and where the opening can go. Then we look at the roof covering outside to choose the correct flashing kit, because a good window with the wrong flashing will leak. This stage takes time but prevents most later problems.
Any structural work is explained before it starts, and the opening may need planning or Building Regulations checks, which we advise on before work starts. Lining, insulation and vapour control are finished neatly inside so the room stays warm and free of condensation. We leave the room tidy.