Why verges fail on Ridgeway houses
Many of the houses in this part of north-east Bristol are hipped, so the verge only appears at the gable ends of side extensions, garages and the odd semi-detached end wall. Those short verges often get the least attention, which is why they are the ones where the mortar has gone. We measure each one up on site rather than guessing.
A common first sign is grit or lumps of mortar on a path, drive or garage roof below. By then water is usually getting under the edge tiles, and it can reach the barge timbers and the wall plate. Birds and insects also find their way into a broken verge. Left alone, that is how a small repair turns into a bigger one.
A dry verge takes away the part that fails. The units are fixed to the roof structure following the tile maker's guidance, which holds the edge down in wind. Whether it suits your roof depends on the tile profile, and we check that on site before we say yes. If it does not, we say so and suggest another way to finish the edge.
Dry verge work around Ridgeway
- Replacing failed verge mortar. Removing cracked and fallen mortar and fitting verge units in its place, so the edge no longer relies on a wet bedding that will crack again.
- Dry verge on a re-roof. Building the verge into a new covering from the start, with fixings and units matched to the tiles being laid.
- Garage and extension gables. Fitting dry verge to the gable edges of garages and side extensions, which are often the shortest and most neglected verges on the house.
- Tile-end and cap pieces. Supplying and fitting the end pieces that finish the verge neatly where it meets the ridge and the eaves.
- Verge inspection. Looking at the whole verge line for loose tiles, rotten barge timbers or missing pointing, and telling you what really needs doing.
- Edge tile re-fixing. Re-fixing loose or shifted tiles along the verge before the new units go on, so the whole edge sits properly.
How we fit a dry verge in Ridgeway
We begin by checking that the tile profile on your roof works with a dry verge system, because compatibility varies. We also look at the condition of the tiles, battens and barge timber along the edge, since a dry verge cannot cure a roof that is failing elsewhere.
Access to a gable edge usually means a ladder or tower from the side, and we keep falling debris away from paths and cars. The old mortar comes off, the units are fixed to the maker's guidance, and we show you the finished edge. You will not have a mortar line to crack again.