Eaves, verges and weather on Lawrence Weston estates
Because the estates are open to wind from the Severn side, rain here is often driven sideways into the eaves. A fascia that has been wet and dry again and again softens first at the joints and the lower edge, and the gutter bracket screws then loosen in the soft wood. A close look at those joints usually shows whether one length needs replacing or the whole front elevation does.
Short terraces and semis have long uninterrupted eaves runs, so a failed joint or sagging length in one place often points to trouble along the rest. We walk the whole run from the ground before quoting anything, and look for stains below the gutter that mark a long-term overflow. Replacing only the worst length can leave a mismatch, so we talk through the sensible extent of the work with you.
Many of the garages share the same eaves detail as the house. Where a garage fascia has rotted we can renew it at the same time, so the front of the property matches rather than ending in a patchwork of old and new. That also means the gutters and downpipes on the garage can be put right in a single visit, with the access already in place.
Fascia and soffit work in Lawrence Weston
- Full fascia and soffit replacement. Old boards and gutters removed, rafter ends checked, then new UPVC fascias and soffits fitted around the whole house.
- Bargeboards at the gable. Gable-edge boards on semis and end-of-terrace houses renewed so the verge finishes cleanly and rain stays out of the roof edge.
- Vented soffits. Ventilated soffit boards or vent strips fitted so the roof space gets air and condensation does not collect in the loft.
- Gutter replacement alongside. New guttering and downpipes fitted with the boards, so the falls are right and the system is not worked on twice.
- Capping over sound boards. Covering boards that are still solid with UPVC capping, where the timber underneath is healthy enough to stay.
- Repairs and partial replacement. Replacing a single rotten length or a garage run when the rest of the eaves is in good order.
How we replace fascias and soffits in Lawrence Weston
Scaffold or proper access is needed to do this safely, and we sort that before work begins. Once the old boards and gutters are off, we look at the rafter ends and the eaves behind them. If any timber has gone soft, we tell you before we cover it, not after. We would rather show you a soft rafter end and agree a plan than leave it hidden behind a smart new board.
On older houses we check what the existing soffit boards are made of before disturbing them, and we handle them accordingly. Finishes come in white, darker colours and wood effect. Larger changes may need planning or Building Regulations checks, and we advise before work starts. We talk through the finish with you before ordering, so the boards are right for the house when they go up.