Roof windows in Barton Hill homes
Victorian terraces here usually have a roof space that could be used, and a rear slope is a natural place for a window. Slate and old tile coverings each need a flashing kit made for them, and we choose the kit before anything is cut. The back slope of a terrace is usually the neater choice, since it leaves the front of the house looking as it always did.
The later council-built houses have plainer roofs, often with concrete or clay tiles. Their rafters and spacing are different from Victorian roofs, so we check the structure in the loft instead of assuming it will match the next house. Older homes tend to need more care at the opening, and we will point out anything unusual we find in the roof timbers.
Some Barton Hill houses have lofts already converted or part-used, and replacing a tired window there is a separate job from adding a new one. We look at the old flashing and lining, which often explain why a window has been leaking. Whichever kind of roof you have, the window sits correctly only if the flashing suits the covering.
Roof window work in Barton Hill
- New roof window installation. A new opening is cut and framed, the window flashed to suit the covering, and the lining finished inside so the room looks complete.
- Replacing old roof windows. Leaking or worn windows are removed and replaced, with new flashing fitted so the surround is properly watertight again.
- Loft conversion windows. Windows for a converted loft are set for light and headroom, with rafters trimmed and doubled up where our on-site check shows it is needed.
- Flashing kit matching. Each window is paired with a flashing kit made for your slate or tile, so water runs over the covering and away from the opening.
- Misted glass units. Misting between the panes means the sealed unit has failed, and we replace the unit or window without disturbing more roof than necessary.
- Leak diagnosis. Leaks near a roof window usually come from flashing, sealing, condensation or the nearby covering, so we trace the true cause first.
How we fit roof windows in Barton Hill
We start in the loft, looking at the rafters, insulation and the position where the opening can go without weakening the roof. Rafters may need trimming and doubling up, and we confirm that on site instead of guessing from outside. That check also shows us the state of the roof timbers and insulation near the opening, which we report to you.
Outside, we match the flashing to the covering and plan how to keep the roof dry while the opening is cut. Inside, lining, insulation and vapour control around the window are fitted so the room stays warm and free of condensation. The room is left tidy and ready for use once we finish.